Description

INVERTER ΚΑΘΑΡΟΥ ΗΜΙΤΟΝΟΥ VICTRON PHOENIX INVERTER 24/3000 SMART 3000VA 24V

Ενσωματωμένο Bluetooth: πλήρως διαμορφωμένο με tablet ή smartphone
– Ειδοποίηση χαμηλής τάσης μπαταρίας
– Επίπεδα διακοπής τάσης χαμηλής μπαταρίας και επανεκκίνηση
– Δυναμική αποκοπή: στάθμη αποκοπής εξαρτώμενη από το φορτίο
– Τάση εξόδου: 230VAC
– Συχνότητα: 50 Hz
– Ενεργοποίηση / απενεργοποίηση λειτουργίας ECO και επίπεδο αίσθησης λειτουργίας ECO
– Ρελέ συναγερμού

Παρακολούθηση:
– Τάση εισόδου και εξόδου, φόρτιο και ειδοποιήσεις

VICTRON PHOENIX INVERTER 24/3000 SMART 3000VA 24V

Ισχύς : 3000VA

Εύρος τάσης εξόδου : 18,6 – 34V

Διαστάσεις : 487x286x152mm

Προστασία αδιαβροχοποίησης : IP21

Βάρος:19kg

ΕΓΓΥΗΣΗ 5 ΧΡΟΝΙΑ

Made in Netherland

Τεχνικές πληροφορίες Phoenix Inverters Smart 1600VA – 3000VA

Bluetooth built-in: fully configurable with a tablet or smartphone
• Low battery voltage alarm
• Low battery voltage cut-off and restart levels
• Dynamic cut-off: load dependent cut-off level
• Output voltage: 210 – 245V
• Frequency: 50 Hz or 60 Hz
• ECO mode on/off and ECO mode sense level
• Alarm relay
Monitoring:
• In- and output voltage, load and alarms
VE.Direct communication port
The VE.Direct port can be connected to a computer (VE.Direct to USB interface cable needed) to
configure and monitor the same parameters.
Proven reliability
The full bridge plus toroidal transformer topology has proven its reliability over many years.
The inverters are short circuit proof and protected against overheating, whether due to overload
or high ambient temperature.
High start-up power
Needed to start loads such as power converters for LED lamps, halogen lamps or electric tools.
ECO mode
When in ECO mode, the inverter will switch to standby when the load decreases below a preset
value. Once in standby the inverter will switch on for a short period every 2,5 seconds
(adjustable).
If the load exceeds the preset level, the inverter will remain on.
Remote on/off
A remote on/off switch or relay contact can be connected to a two pole connector.
Alternatively, the H terminal (left) of the two pole connector can be switched to battery plus, or
the L terminal (right) of the two pole connector can be switched to battery minus (or the chassis
of a vehicle, for example).
LED diagnosis
Please see manual for a description.

Phoenix Inverters Smart 1600VA – 3000VA

To transfer the load to another AC source: the automatic transfer switch
For our low power inverters we recommend our Filax Automatic Transfer Switch. The Filax
features a very short switchover time (less than 20 milliseconds) so that computers and other
electronic equipment will continue to operate without disruption. Alternatively use a MultiPlus
with built-in transfer switch